Skystars RC F722 Mini HD Pro Flight Controller

Description: The Skystars RC F722 Mini HD Pro is a 20x20 flight controller with a powerful F7 processor, 6 UARTs, dual 5v and 10V BEC, barometer, built-in blackbox, and more. All this fits on a small board measuring just 35x28mm and weighing only 4.8g. Features: Solder pads are the largest in size compared to other similar sized FC in market. Proper solder pad spacing to avoid solder bridge and facilitate easy soldering. ESC connector on top-side rather than bottom which makes it easy for repair. Hybrid design allows both M3 and M2 screws. TVS Diode for Reverse Polarity Protection and Voltage Spike Suppression. Powerful BEC to supply all your electronics. Pads arrangement are executed in such a way that when you twist the wires of the camera VTX and RX you don’t get any wire overlapping this gives you a uniform twist and clean look. DJI connector on the bottom side. Budget-friendly price ( We understand the situation of chip shortage and rising prices of FC ) Two stages of Quality check to reduce any faulty electronic. No power lines near Gyro to avoid any EMI interference. Comes ready with I2C support and INAV. Specifications: Item name: F405Mini HD2 Betaflight Flight Controller Input voltage: 3-6S LiPo(11.1V~22.2V) MCU: STM32F405RGT6 168MHz IMU: MPU6000 or BMI270 OSD: Betaflight OSD &DJI HD OSD (UART6) 6 hardware UARTS (UART1,2,3,4,5,6,) Receiver: TBS/PPM/SBUS/IBUS/DSM Barometer: YES Buzzer Pad: YES CURR Pad: YES BEC 5V 2A & 10V 2A(Max 3A) Blackbox: 16MB Firmware: Betaflight /INAV SKYSTARS F405HD Mounting Holes: 20mm/M2 or M3 Weight: 4.8g Includes: 1x Skystars RC F722 Mini HD Pro Flight Controller 8x Anti-vibration Grommets 1x Wiring Harness

Price: 55 USD

Location: Madison, Alabama

End Time: 2024-08-12T00:33:55.000Z

Shipping Cost: N/A USD