Rootx 4lb Jar With Funnel Applicator

Description: ROOTX - 4 Pound Jar Container of Root Killer For Sewer Drain Pipes. Kills Roots In Your Plumbing Sewer Drain Pipes. What is included in this listing?? NEW- 1 container of RootX root killer in 4 lb. jar. Funnel applicator Description: Kill pipeline roots—avoid costly repairs RootX® makes it easy for your plumbing professional to kill roots in residential sewer lines, storm pipes and septic systems. Root intrusion may be the single most destructive element facing your home’s wastewater collection system. Left untreated, roots will spread throughout the pipe. Material passing down the drain gets trapped in the roots, restricting the flow or even causing a complete blockage. Root intrusion can eventually destroy a sewer or septic system, costing thousands of dollars to repair or replace. We recommend annual RootX treatments to keep your system root free and avoid costly sewer and septic tank repairs. Ask your plumbing professional about our annual reminder program. Kill pipeline roots—restore pipe flow capacity The patented RootX formula foams on contact with water to reach the top of the pipe where 90% of the roots are. Degreasing agents strip away grime so the RootX herbicide can penetrate the roots, killing them on contact. RootX sticks to the pipe walls, preventing re-growth for up to three years. Dead roots decay over time, restoring pipes to their full capacity. Tough on roots; easy on pipes RootX kills roots using the aquatic herbicide Dichlobenil. It’s non-caustic, non-fumigating and non-systemic, and it contains no diquat dibromide, copper sulfate or metam sodium. RootX will not harm pipes, septic systems or above-ground vegetation (not for use in septic systems in the state of Florida). EPA registration #68464-1 RootX is registered for use in all 50 states as well as Canada, and it’s classified as a General Use product by the Environmental Protection Agency. In addition, RootX carries the signal word CAUTION, the lowest chemical hazard rating according to the ISO 3864-2 standard for hazard severity panels. How RootX works RootX is a simple, cost-effective and proven way to kill pipeline roots in sewer lines, storm pipes and septic systems (not for use in septic systems in the state of Florida). RootX uses the aquatic herbicide Dichlobenil. It’s non-caustic, non-fumigating and non-systemic, and it contains no diquat dibromide, copper sulfate or metam sodium. RootX is classified as a General Use product by the Environmental Protection Agency, and it’s registered for use in all 50 states (EPA registration #68464-1) as well as Canada. In addition, RootX carries the signal word CAUTION, the lowest chemical hazard rating according to the ISO 3864-2 standard for hazard severity panels. Foaming RootX formula kills roots The patented RootX formula foams on contact with water. The foam acts as a carrying agent, lifting the herbicide to the top of the pipe where 90 percent of pipeline roots grow. De-greasing agents strip away grease and grime so the active ingredient can penetrate the roots, killing the root tissue on contact. RootX promotes bacterial growth to speed the decay and natural removal of roots. The foam also leaves a thin layer of the RootX herbicide on the pipe walls to prevent re-growth. Enhances mechanical root cutting Mechanical root cutting is an immediate and short-term solution to relieving pipeline blockages caused by root intrusion. However, cutting roots is like pruning a tree; it stimulates even more vigorous and destructive root growth in the remaining roots. That means new root growth can fully clog your pipe again in just nine months. Treating pipes with RootX not only kills all the roots on contact, it also leaves a thin layer of the herbicide on the pipe walls to prevent roots from coming back. New root growth after treatment with RootX is much slower and less destructive to the pipe. If this is the first time you’re treating a pipe or if it is completely blocked, it makes sense to use mechanical cutting to remove the root mass and restore pipe flow right away. However, you can kill any remaining roots in the line and stunt re-growth longer by applying RootX immediately after mechanical cutting. It’s important to apply RootX within the first hour after cutting or wait six to eight weeks. That’s because roots release a traumatic acid to cover the cut ends and protect them against further injury. If you apply RootX immediately after cutting, the herbicide can penetrate the root ends before the traumatic acid coating is complete. After six to eight weeks, the traumatic acid will have dissipated, leaving the most vulnerable part of the root—the white tender meristem growth where cells are actively dividing—exposed to the herbicide. The more root tissue you can treat with RootX, the better. Once you've put your pipelines on a maintenance program with annual RootX treatments, you should be able to eliminate mechanical root cutting in most cases. FAQs How do roots grow in sewer pipes? As trees and plants mature, their underground root system grows and naturally seeks out moisture. The most consistent source of moisture is sewer and wastewater pipelines. Joints and cracks in the pipe create natural entry points for roots. Roots start to grow at the top of the pipe and spread. Is root intrusion a serious problem? It can be. According to the Environmental Protection Agency, root intrusion is probably the single most destructive element involved in maintaining a wastewater collection system. Left untreated, roots will spread throughout the pipe. Material passing down the drain gets trapped in the roots, restricting the flow or even causing a complete blockage. Root intrusion can eventually destroy a sewer or septic system, costing homeowners thousands of dollars to repair or replace. How is chemical root control with RootX different from mechanical cutting? Treating pipes with RootX takes less time than mechanical cutting, and the results last longer. Mechanical root cutting leaves some roots behind in the pipe. Cutting roots is also like pruning a tree; it stimulates vigorous re-growth in the remaining roots. That means new root growth can fully clog your pipe again in just nine months. What’s more the cycle of cutting roots, re-growth and cutting again will eventually destroy the structural integrity of the pipe. RootX kills roots on contact; the dead roots decay over time and are carried out with the flow of the pipe, restoring the pipe to its full capacity. RootX also leaves a barrier on the pipe walls to prevent future root growth. Once you’re on a maintenance program with annual RootX treatments, you should be able to eliminate mechanical root cutting in most cases. Should I use RootX together with mechanical root cutting? If this is the first time you’re having your pipes treated or if the pipe is completely blocked, your plumbing contractor can clear away the immediate blockage by cutting the roots first. Then he’ll use RootX to kill the remaining roots and leave a barrier on the pipe to prevent re-growth. Make sure your plumber applies RootX within one hour of cutting the roots; this ensures the remaining root structure properly absorbs the RootX herbicide. Otherwise, he’ll need to wait 6-8 weeks before using RootX to allow root ends to develop. What’s the best location for applying RootX? The cleanout is the preferred method for most residential applications because it’s closest to the pipes where roots can cause problems. If there’s no cleanout at your house, your plumber can apply RootX using the toilet. To prevent foam overflow outside the pipeline, he should only use a 2-lb. jar of RootX in a toilet application. How long does it take to apply RootX? Your plumber can treat your sewer or septic system by applying RootX in a cleanout or pouring it into a toilet. It takes just minutes to complete a RootX treatment. How quickly can I expect results with RootX? RootX kills roots on contact and destroys the root structure within the first hour after application. The roots decay in over time depending on the type of plant and the size of the root mass. In extreme cases where the pipe is completely blocked or close to it, your plumber should use mechanical root cutting to clear the blockage, followed immediately by RootX to kill the remaining roots and prevent re-growth. What kind of chemicals does RootX use? RootX kills roots using Dichlobenil, a proven aquatic herbicide. RootX also contains degreasing agents that strip away the grime on roots, allowing the Dichlobenil herbicide to penetrate the root ends. Unlike other root control chemicals, RootX contains no diquat dibromide, copper sulfate or metam sodium. Is RootX harmful to the environment? No. The RootX formula is non-caustic, non-fumigating and non-systemic. It is classified as a General Use product by the Environmental Protection Agency and is registered for use in all 50 states (EPA registration #68464-1). In addition, RootX carries the signal word CAUTION, the lowest chemical hazard rating according to the ISO 3864-2 standard for hazard severity panels. Does RootX harm trees and plants? No. RootX only kills the roots inside the pipe and prevents their re-growth. Since the RootX foam only flows through the pipe, it has no effect on roots outside the pipe. Can RootX be used in septic systems? Yes. RootX can be poured directly into the septic tank and distribution box to kill roots that have intruded into the tank and drain field lines (not for use in septic systems in the state of Florida). Is RootX hard on pipes or septic systems? No. RootX contains no diquat dibromide, copper sulfate or metam sodium. The RootX formula is non-caustic, non-fumigating and non-systemic. RootX also promotes bacterial growth, which is good for septic systems (not for use in septic systems in the state of Florida). By contrast, mechanical root cutting, which cuts and tears at roots that become embedded in the pipe walls, can eventually destroy a pipe’s structural integrity. Will the RootX foam stop or block any flow during application? No. RootX foams on contact with water, and it uses the natural flow of the line to spread the foam throughout the pipe. Wastewater continues to flow under the foam, so using RootX does not cause any service interruptions. However, you should reduce water use for at least an hour to allow the RootX foam to fully spread and soak into the roots. How long does it take the RootX foam to dissipate after application? The fast-acting RootX foam will normally dissipate in about 15 minutes. How often do I need RootX treatments? You should treat your sewer lines or septic system every year

Price: 95 USD

Location: Crown Point, Indiana

End Time: 2024-08-26T16:19:16.000Z

Shipping Cost: 0 USD