Point Controller (turn-out Controller) for 2 points.

Description: Normal 0 false false false MicrosoftInternetExplorer4 POINT CONTROLLER - for 2 Points This is the latest design from Talking Electronics to convert 2 manual points to remotely operated points. Cost of the module is $25.00 usd plus $12.00 usd postage The project comes complete and fully wired with 2 converted servos on two metres of twin lead. The front panel shows the position of each point via LEDs and the toggle switches select the position of each point. The converted servos only travel 90 degrees or less and you can adjust the travel by altering the output voltage of the Automatic pre-voltage module. This module needs a supply from 9v to 20v and it outputs a constant voltage, set by the 10-turn pot on the module. To reduce the voltage, turn the screw a very small amount clockwise. You can measure the output voltage with a meter as the adjustment is very sensitive. The converted servos are called a MOTOR AND GEARBOX and come with a spring-steel "push-rods" that also acts as a lever when you are fitting (the motor and gearbox) under your layout. The holes in the "arm" allow different "throws" to be achieved for both top and under your layout. Holders for the motor are available from Talking Electronics for $2.50 each and come with screws to hold the servo and for mounting the bracket. Use the tiny screws provided to hold the face-plate in place and the small screws to hold the arm onto the output shaft of the gearbox. You can input AC or DC to the pre-voltage module and the current-limiting resistors are needed to prevent the supply module being overloaded and the other limiting resistors allow the motor to be fed for a longer period of time to achieve the desired rotation. This is the only module on the market with these features.

Price: 25 USD

Location: Springvale South, VIC

End Time: 2024-12-28T07:59:45.000Z

Shipping Cost: 12 USD