P608667 For Donaldson Air Filter Primary Obround Powercore 87356545 CA5791 49667

Description: P608667 Obround Air Filter Fit for Case, Case-IH, New Holland Tractor Wheel loaders Crawler loader Replaces 87356545 CA5791 49667 Product Description Fit for: Case, Case-IH, New Holland equipment. Filter Cross Reference: 568310D1; CA5791; 226780; 52RS028278; 87356545; A0040946404; 9667; 10KP782; 55187529; 8014785; SL82022; 15504715; 30076076; 49667, 549667. Function: Effectively filter out dirt and sand particles in the air, ensure sufficient and clean air enters the cylinder, and avoid engine performance degradation and fuel consumption increase due to premature wear and tear. Note: To ensure that clean air reaches the engine, replace the air filter regularly as needed. Package includes: 1 * P608667 Air Filter. Install： 1. Remove the primary filter Shut off the engine. Push down on the service handle to tilt the filter to a 5º angle. This will loosen the seal. Then, pull up on the service handle to remove the filter from the housing. 2. Visually inspect the safety filter Remove any excess dirt and wipe out the housing with a damp cloth before servicing the safety filter. The safety filter should be replaced every three primary filter changes. 3. Remove safety filter if indicated or if excessively contaminated To remove the safety filter, use the plastic handle on the face of the safety filter. Pull the filter toward the center of the housing and remove it. Ensure that the outlet tube sealing area is clean and undamaged. If the safety filter is removed and the new filter is not to be installed immediately, be sure to cover the seal tube with a cloth so that dirt is not admitted. After removing the safety filter, wipe the air cleaner housing interior and seal surfaces with a clean, damp cloth. 4. Replace the safety filter Slide the filter at an angle into the outlet side and push it in place until the filter seats firmly and evenly within the housing. 5. Insert the primary filter Slide the filter down at approximately a 5º angle until it makes contact with the end of the housing. Rotate the filter toward the outlet section to complete the seal. Place the service cover in position and fasten the metal latches. If the cover doesn’t seat, remove and re-check the filter position and access cover orientation. 6. Inspect the entire air cleaner system Make sure that inlet and outlet connections are in good condition. Torque to and do not exceed 40 in/lb. Replace rubber connectors if necessary and reset the service indicator.

Price: 221.66 USD

Location: wuhu

End Time: 2024-12-27T01:37:50.000Z

Shipping Cost: 0 USD