Lot of Christmas Themed Milky Wax Molds - NEW- Soap, Lotion Bars, Wax, Bath Bomb

Description: This Lot includes 12 NEW Christmas Themed Clear PVC Molds for Soap, Wax, Lotion Bars, and Bath Bombs. 12 Molds with 3 different design and 1-3 cavities per mold. These molds are perfect for soap, lotion bars, bath bombs, shower steamers, and wax (when poured under 135°) Included:10 - Rectangle Single Cavity "Gingerbread Man" Package Mold with LidCreate a classic bar of soap with this Rectangle Clamshell. This clamshell comes with snap-on lid for a convenient way to package your product. Simply pour in your soap, wax or lotion bar or pack with your bath bomb mixture, label and they are ready to go! Material: Plastic Avg. Bar Weight: 3.85 oz Bar Cavities: 1Bar Depth: 1" Bar Length: 3.3125"Bar Width: 2.125" Max Temperature: 140°F Mold Capacity (oz): 3.85Directions:Pour soap/lotion bar/wax base into mold and let harden. Let cool and harden before closing. When used for CP Soap, we recommend leaving the mold open for 4-6 weeks until soap is cured. 1 - Snowflake - 3 Cavity Mold 1 - Rectangle "Joy" - 3 Cavity Mold Manufacturer: Milky Way Molds Material: Clear PVC (Not Approved for Food Contact) Country of Origin: United States Milky Way Soap Molds can tolerate temperatures of 135°-145° F. Above these temperatures, warping may occur. Soap/Wax is easiest to release 12-24 hours after cooling. Directions:Melt & Pour Soap & Wax: Pour melted soap/wax at a temperature no higher than 135ºF into mold. Cool until hardened. Remove from mold. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold. Cold Process Soap: Coat the mold with cooking spray. Pour soap at trace into mold. After 24 hours, flip mold over onto a clean surface. Gently push the back of the mold until the soap begins to release then pull the soap out of the mold with a gloved hand. Allow soap to cure for 4-8 weeks. Note that some CPsoap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster. Lotion Bars: Pour melted lotion bar mixture into mold cavities at a temperature no hotter than 135ºF. Allow mixture to solidify. Flip mold over onto clean surface. Gently push back of mold until lotion bar begins to release then pull bar out of mold. Care:Wash in warm, sudsy water. Please avoid the dishwasher because that can warp your molds or make them brittle.

Price: 15 USD

Location: Brookfield, Connecticut

End Time: 2024-08-23T18:21:28.000Z

Shipping Cost: 0 USD