Directed 556UW UNIVERSAL REMOTE START INTERFACE W/ SELECTABLE WINDINGS

Description: BRAND NEW DIRECTED 556UW UNIVERSAL REMOTE START INTERFACE W/ SELECTABLE WINDINGSSELECTABLE KEY WINDINGS FOR PRECISION RF TUNING THIS PRODUCT REQUIRES PROFESSIONAL INSTALLATIONUNIVERSAL REMOTE START INTERFACE W/ SELECTABLE KEY WINDINGS: Working ignition key required for operation. The 556UW remote start immobilizer interface module is used when installing remote start products in vehicles equipped with a transponder or RF (Radio Frequency) based immobilizer system. This type of system uses a small chip imbedded in the ignition key, called a transponder, to transmit a very low powered RF signal. This signal is picked up through an antenna (or coil) around the ignition switch which is then sent to the immobilizer’s transceiver. Once the correct signal is received, the immobilizer will enable the ignition and/or fuel systems. If an attempt is made to start the vehicle and the transceiver does not receive a valid code, the ignition and sometimes the fuel systems are disabled. The immobilizer system will then not allow the remote start to successfully start the vehicle. The 556UW bypasses the immobilizer system only while the remote start is in use, maintaining the factory system’s integrity. When the remote start system is not in use the factory immobilizer remains fully functional. Notes:Requires use of a spare key for the vehicle.Replaces 555U, 555UW, 555B, 555BWSelectable key windings provide ability to tune kit to specific transponder frequency used by different manufacturers.Simple jumper selection to tune kit for European vehicles (60 windings) or domestic (18 windings)Tamper prevention circuit provides ability to open keysense circuit to prevent immobilizer module from reading two RFID's at once and going into tamper mode.Keysense trigger provides ability to shut off universal transpondear bypass as soon as driver’s ignition key is put into cylinder for key take over. This prevents the vehicle from detecting the 2nd RFID of driver’s key and causing a tamper code. Works with any aftermarket remote start system.Compatible with the factory anti-theft systemMaintains the integrity of the factory anti-theft systemTwo, jumper selectable antenna ring settings.Compact design, easy to mount.No programming requiredMaintains the integrity of the factory anti-theft system 6-PIN HARNESSRED (+) 12 Volt Input: Connect this wire to a fused source of constant 12V.BLUE (-) Status Input: Connect this wire to the remote start negative (-) status output.PINK (+) Ignition Input: Connect this wire to the vehicle’s true ignition output. BLACK (-) Chassis Ground Input: Connect this wire to the vehicle’s chassis ground.VIOLET (+) Keysense Input: Connect this wire to the vehicle’s positive keysense output wire. GREEN (-) Keysense Input: Connect this wire to the vehicle’s negative keysense output wire. 3-PIN HARNESSBLACK and BLACK/RED Wires: Both of these are antenna ring wires.BLACK/WHITE: Refer to alternate wiring diagram. Protect Your Product With a Consumer Priority Service Warranty Shipping Items will be shipped same or next business day (Monday through Friday) after payment is cleared via USPS or UPS with tracking and delivery confirmation. Customer Support We strive for 5-star customer satisfaction. If you are not happy with your purchase, please contact us immediately via eBay message. We will do our best to make it right! If you have any questions/concerns regarding your purchase, please contact us through the eBay messaging system immediately, and we will get back to you ASAP!

Price: 19.99 USD

Location: Brooklyn, New York

End Time: 2024-07-26T19:11:11.000Z

Shipping Cost: 0 USD