Brand New, Surgex SX-1120 iP-X 20amp Power conditioner, 1 RU

Description: Surgex SX-1120 iP-X 20amp Power conditioner, 1 RU. Brand New, Never used. Purchased for a project that never happened. The SurgeX iControl SX1115iP (SX1120iP) is a single rack-space, 120V, 15 (20) amp, AC power conditioner that can be controlled over a network or the internet. The simple web server structure allows basic control of the receptacles and viewing of status information all from the home page. The extensive programming and setup capabilities are available and explained in the online manual, however it works just fine stand alone.The eight rear-mounted receptacles can each be individually controlled, and the current and energy consumption of each receptacle can be obtained through the network interface. The metering includes the AC line voltage and current draw, and all measurements (voltage, current and power) are true RMS readings. Thus, the current draw and energy consumption of non-linear electronic loads which have a power factor of less than unity will be correctly reported. Incorporating SurgeX Advanced Series Mode power conditioning and surge elimination, the iControl is rated A-1-1, the highest standard of performance and endurance. Also included in the iControl package are the SurgeX Impedance TolerantEMI/RFI filtering and SurgeX ICE Inrush Current Elimination circuitry (on receptacles 1 and 2). SurgeX ICE eliminates problemsassociated with inrush currents from large loads such as amplifiers. With SurgeX ICE, it is not necessary to take inrush currents into account when designing the AC power for a system.Special time-delay circuit breakers are not required – it is necessary only to ensure that the average currents of all products plugged into the iControl are within the 15 (20) Amp product rating.There are two 6-pin pluggable terminal blocks on the rear panel, one of which provides connectivity for an external wired temperature sensor which can be situated anywhere in the rack,The four front panel LEDs provide indication of AC power (red), network connectivity (yellow), shutdown status (orange) and surge protection status (green).The extensive programming capabilities of the iControl allow sequencing and scheduling to be set up, not just for the host unit, but also for other iControl units on the same network. User Defined Actions can be programmed to activate on an "if X then do Y" basis. Triggers include: AC line voltage, total unit current draw, individual receptacle current draw, and temperature.Actions include: turning receptacles on and off, executing previously-defined sequences, and sending emails. For example, an action can be created to send an email if the rack temperature exceeds 35C.

Price: 325 USD

Location: Irvington, New York

End Time: 2024-10-17T18:34:39.000Z

Shipping Cost: N/A USD