Adjustable Charger 1A - 50A 2.6V~ 29.4V Voltage Lifepo4 Li-ion Lithium Charge

Description: Adjustable Charger 1A - 50A Current 2.6V~ 29.4V Voltage 12V 14.6V 24V Lifepo4 Li-ion Lipo Lithium Fast Charge 1S 2S 3S 4S 8S 7S prompt Customers who need to change for the Anderson plug, will maintain the original output wire length, solder the wire from the clip, and then install Anderson! It is absolutely not allowed to arbitrarily modify the output line to be bold, lengthened, shortened, etc., causing a large current error or even damage. The black negative wire of the charger has a thin detection wire, which cannot be replaced, lengthened, or cut short. Otherwise, the current accuracy will be affected. (After shortening, the display current will become smaller, but the actual current will become larger. If the rated power is exceeded, it will burn.) If you install an Anderson plug or add an extension cord, you must ensure that the original wire of the charger is correct. The length remains the same, absolutely can’t be shortened and modified information Input voltage: AC 100v/110v --220v/250v Input power: the new version750W. Old version 675W Output voltage: DC constant voltage meets 2.6V-14.6V (suitable for 1S to 3S Li-ion Lipo and 1S to 4S Lifepo4) Output current: DC constant current is adjustable to 1-50A. (only constant current and constant voltage can be used as charger) Protection method: After the positive and negative poles are short-circuited, constant current output Appearance size: new version length 36CM* width 5.5CM* height 5.5CM. Cooling method: Air-cooled (built-in cooling fan, increasing speed with increasing temperature) Attached accessories: With two positive and negative wires and clips, (the power cord wire needs to be prepared by yourself) The output wire uses 80A high quality silicone wire. Note: (Important things are repeated three times!) Connect the battery positive and negative can not be reversed (Red Positive + ; Black negative - ), the reverse will be bad, AC 100V-250V. have over current protection ,short circuit protection . after protected , adjust current knot power off and re-start only "2V-15V polar protect " version have + - polarity protection . Instructions: The first step: the charger should not be connected to the battery, turn on the power, adjust the voltage knob to adjust the voltage, refer to the voltage display above the display screen, (4S lifepo4 battery 3.65v*4=14.6 volts, 3S li-ion lipo battery 4.2v *3=12.6V), adjust to the voltage you need. Step 2: Adjust the current to a minimum. After connecting the battery, adjust the current from small to large and adjust to the current you need. (In the charging process, it is not allowed to adjust the voltage knob again, otherwise overcharge or undercharge will occur) If the voltage is displayed, the voltage you set, the current becomes zero, and it is already full.

Price: 95.7 USD

Location: shenzhen

End Time: 2023-12-24T14:49:17.000Z

Shipping Cost: 26 USD